ARC-1 Operations & Technical Guide

Coming soon

The test and service buttons are located to the right of the inner coin door.

show photo of the door open and the buttons
show photo of the door open and the amp

To install a game cartridge, please follow these steps:

1. Move the cabinet into an open area so you can access the back door.
2. Remove the back door and set it aside.
3. Insert the game cartridge into the exA-Arcadia system.
4. Restore all components back to where they were.

show photo of the backside open and where the system is

To rotate the monitor, please follow these steps:

1. Move the cabinet into an open area so you can access the back door.
2. Remove the back door and set it aside.
3. Remove the HDMI and power cables from the back of the monitor.
4. On the back side of the cabinet, remove the screws securing the monitor on the bracket.
5. Remove the screws from the acrylic panel on the front side of the cabinet.
6. Remove the bezel from the front of the cabinet.
7. From the front side of the cabinet, pull out the monitor and rotate it 90 degrees counter clockwise.
8. Place the monitor back in the cabinet.
9. Restore all components back to where they were.

show photo of the back of the cabinet with the door off
show photo of the front acrylic panel with the screws

To change the marquee, please follow these steps:

1. Remove the x # of screws from the top of the marquee area.
2. Slide out the installed marquee.
3. Insert the new marquee.
4. Return the x # of screws.

To install new instructions strips, please follow these steps:

1. Remove the x # of screws from the acrylic panel on the front side of the cabinet.
2. Use masking or scotch tape and apply to the back of the instruction strip.
3. Put the instruction strip in the desired area.
4. Restore all components back to where they were.

show photo of the screws on the marquee area

Coming soon.

Unscrew the joystick or button from its original location and install the new replacement part.

Connect the 2 wires to the Game Menu button.

show photo of the control panel underside

Use a dolly to prop the cabinet on its back side then roll it to the desired destination.

Please read the System Support Error page for the IO Error resolution.

Please read the System Support Error page for the Error 28 resolution.

Please read the System Support Error page for the Error 36 resolution.

Please read the System Support Error page for the Error 37 resolution.